Society for Testing and Materials (ASTM) methods will be used for .. Provider. From ASTM. D 5 Samples from powder coating lot to. Find the most up-to-date version of ASTM D at Engineering ASTM D Standard Guide for Testing Coating Powders and Powder Coatings.

Author: Votilar Grolrajas
Country: Mauritius
Language: English (Spanish)
Genre: Education
Published (Last): 5 August 2009
Pages: 142
PDF File Size: 20.81 Mb
ePub File Size: 19.81 Mb
ISBN: 586-4-77324-140-7
Downloads: 2317
Price: Free* [*Free Regsitration Required]
Uploader: Ferisar

Horizontal Flammability Tester Where more than one test method is listed for the same characteristic, no attempt is made to indicate superiority of one method over another.

ASTM D – 06() – Standard Guide for Testing Coating Powders and Powder Coatings

Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, ast, entirely their own responsibility. The test methods included are listed in Table 1.

If the document is revised or amended, you will be notified by email. The cured weight loss may be requested in order to properly determine the exhaust requirements of a zstm oven or to comply with state or federal reporting guidelines.

The test methods included are listed in Table 1.

This is true whether the test is an established test, like salt spray Practice Bor a new test developed to simulate an environmental service condition unique to one given industry.


We have no amendments or corrections for this standard.

Fire Testing Equipment Key test methods or practices are as follows: The following test method indicated has been found suitable for this purpose. It is also important to know at what? The print test can determine the degree of marring due to pressure. Brush the material towards the lower temperature and note the location where particles of powder adhere to the bar when brushed lightly.

It should be noted that many of the methods used for characterizing a coating powder, such as gel time Section 16 and inclined flow Section 17are primarily meant for the relative comparison of two coating powders, rather than to give a test value that can be interpreted as good or bad. Some industries that is, automotive have also adopted the use of Knoop Indention Hardness. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

For the reported hiding power to be signi? Oxygen Index Apparatus A number in parentheses indicates the year of last reapproval.

Selection of the methods to be followed must be governed by experience and the requirements in each individual case, together with agreement between the purchaser and the seller. These properties may be evaluated following the test methods listed in A deviation from the standard bake must be agreed upon between the purchaser and seller.


X3451 properties may be evaluated as follows: Large area view is also recommended whenever possible.

Flow Test Incline Adtm Problems such as changes in gloss, surface appearance, physical properties, and color contamination may occur if incompatible powders are mixed. It is important to point out that the relation between hours of arti?

Spectrophotometers offer a choice of two standard observers, speci? Requirements within therecycled water.

Place the pointer between these two divisions. Some coating powder chemistries can be inherently resistant to impact fusion even though their tack temperature might be relatively low. You can download and open this file to your own computer but X3451 prevents opening this file on another computer, including a networked server. A more sophisticated surface pro?

ASTM D3451 – 06(2017)

I was set up your machine one week ago. Plywood Case Delivery Time: It should be noted however, that pencil hardness is not the most reproducible test and interpreting the results is somewhat d345. Impact resistance is dependent on the substrate type and its preparation, the thickness of the substrate, and the?